Convert Microinch (µin) to Point (pt) instantly.
About these units
Microinch (µin)
A microinch is one-millionth of an inch, approximately 2.54 × 10⁻⁸ meters. It is a precision unit used primarily in engineering, machining, and electronics. Microinches allow engineers to describe tolerances, surface roughness, and component dimensions with extreme accuracy. This is especially relevant in semiconductor manufacturing and microelectronics, where deviations of just a few microinches can impact performance. Although rarely encountered outside technical fields, the microinch demonstrates the need for highly granular units in modern technology, bridging the gap between traditional inches and nanometer-scale measurements.
Point (pt)
A point is a typographic unit traditionally equal to 1/72 of an inch (in digital typography) or 0.352777 mm. Historically, however, the point system varied widely across regions and printing houses. In the era of metal movable type, each foundry often produced its own proprietary sizes, making typefaces and point values incompatible between printers. The modern point was standardized largely due to the demands of the publishing industry and later digital systems, especially PostScript and desktop publishing software. The point became essential because typography requires extremely fine control over letter height, line spacing, and layout—far beyond what conventional measurement systems could easily express. Designers and typesetters rely on points to specify the sizes of fonts, the spacing between lines (leading), and the thickness of rules or strokes. In digital environments, the point remains foundational even though screen resolutions vary. Software uses points as virtual units that are converted into pixels depending on display density. Thus, the point bridges the traditional world of print with modern digital rendering, maintaining continuity in the long history of written communication.